Based in Globe, AZ · working about 75 miles around
Well Pumps · Tanks · Solar · Windmills (928) 961-6641
JACOB'S WELLand Pump Services
Water Booster Pump Repair and Installation in Globe, AZ
Our Services

Water Booster Pump Repair and Installation in Globe, AZ

Booster Pumps · Globe, AZ

House water pressure from a well and storage tank

We do booster pump repair and installation for homes that run off a well and a storage tank. On these homes, the booster pump is the one that gives the house its water pressure. The well pump fills the tank, and the booster draws from the tank and pushes water to the house. When the tank is full but the faucets run weak or dry, the trouble is usually on the booster side.

This well, tank and booster layout is common on low-yield wells around Globe. Our side of the job starts at the well and the water storage tank. It runs through the booster and the pressure tank to the line that feeds the house. We are based in Globe, working Gila County and the country around it, about 75 miles out.

What We Handle

  • Booster pump repair for no water or low pressure at the house with a full tank
  • Lost prime, suction-side air leaks and worn impellers found and fixed
  • Boosters that hum, trip the breaker or will not start, tested on the electrical side first
  • Short cycling traced to a waterlogged pressure tank or the wrong precharge
  • Low-water floats and dry-run protection that shut the booster off before the tank runs dry
  • Pressure switches, check valves and pressure tanks on the booster side
  • Constant pressure (variable speed) booster controls installed and troubleshot
  • New and replacement booster pumps sized to the house and set out of the weather

Booster Pumps Quote

Tell us what your well is doing. We will call or text you back.

How does a well booster pump work with a storage tank?

Penn State Extension calls a well low-yielding when it cannot meet the peak water demand of the home. Many of these wells can still give a small, steady flow all day and night. A storage tank saves that flow for busy times. The same guide's rule of thumb is 100 gallons of storage for every person in the home.

The well pump fills the tank. A float switch turns it on at a set level and off when the tank is full. Penn State Extension describes the next step: a second pump moves water from the storage tank to the pressure tank. That second pump is the booster, and the pressure tank holds pressure between its starts.

University of Arizona Cooperative Extension notes that many tank systems have a second float set lower. It shuts off the booster pump if the water in the tank gets too low. That protects the booster, since a pump maker's manual says running dry can severely damage the pump and its seals.

Booster pump not working? What we check and repair

A full tank with weak or dry faucets points to the booster side. A low tank points back to the well. Penn State Extension says a low-water cut-off in the well should be installed to protect the well pump. Our well pump repair in Globe covers that side.

A booster that runs but will not build pressure has often lost its prime. An air leak on the suction side, between the tank and the pump, can cause that. So can a worn impeller. A booster that hums, trips the breaker or will not start gets its pressure switch, wiring and motor tested first.

A booster that starts and stops every few seconds is short cycling. The usual cause is a waterlogged well pressure tank or a precharge set wrong for the switch. A booster that will not shut off usually never reaches its cut-off pressure. One that has run the tank dry may need new seals or a new pump.

Water pressure booster pump installation around Globe

A new booster gets sized to the flow and pressure the house needs. The climb from the tank up to the house counts too. A well-industry trade journal puts the loss at 0.433 psi for each foot a faucet sits above the pressure tank.

We house each booster out of the weather. A pump maker's booster manual says to keep the suction line short, with as few elbows as possible. It also says to keep the motor dry and never let any part of the system freeze. That means cover from freezing nights in the high country and from summer sun in the low desert.

When we replace a booster, we look over the check valve, pressure switch, low-water float and pressure tank. We also install and troubleshoot constant pressure (variable speed) booster controls. University of Arizona Cooperative Extension notes that switches working daily on or under water can fail and need replacing. That makes floats and switches worth a look on a well maintenance visit.

Steel water storage tank with flexible conduit running down to a control box on a post Gray PVC water line with a red shutoff valve laid along the ground

Ready to get started?

A quote before work begins, across Globe, Miami, Payson, Tonto Basin, San Carlos, Kearny, Mammoth and about 75 miles around Globe.

(928) 961-6641
How We Work

How a Job With Jacob's Well and Pump Services Runs

From the first call to water back at the tap or the tank, here is how it goes.

1

Tell us what the well is doing

Call or text (928) 961-6641, or send the form. No water, low pressure, short cycling or a tripped breaker all point somewhere.

2

We ask about the well

Depth, age, the pump that is in it, and the ADWR registration number if you have one. Those numbers start with 55, and old paperwork tells us what is down the hole.

3

On site, the electrical side first

The pressure switch, control box, wiring and motor readings get tested at the wellhead before anything is pulled.

4

The scope of work, then the quote

You hear what the repair involves and what it will cost before the work starts. Nothing comes out of the well until you say go.

5

The repair, then a tested system

The pump is pulled and repaired or replaced, and the pipe and wire go back right. Then the system is run and checked, and the wellhead is sealed back up.

FAQ

Booster Pumps Questions, Answered

Common questions about booster pumps across Globe, Miami, Payson, Tonto Basin, San Carlos, Kearny, Mammoth and about 75 miles around Globe. If yours is not here, call and ask.

Call (928) 961-6641

Why is there no water pressure at the house when the storage tank is full?
The trouble is usually on the booster side. The booster may have lost its prime, its breaker may have tripped, or the pump may have failed. A stuck or failed low float can also hold the booster off. Call or text (928) 961-6641 and tell us what the pump is doing.
Why does my booster pump keep running?
Usually it never reaches the pressure that shuts it off. A lost prime, an air leak on the suction side or a worn impeller can cause that. So can a leak on the line to the house. A leak inside the house, like a running toilet, is a job for a plumber.
Why does my booster pump turn on and off every few seconds?
That is short cycling, and a waterlogged pressure tank is the usual cause. A precharge set wrong for the pressure switch does it too. Penn State Extension says a 42-gallon pressure tank gives about 8 gallons before the pump starts. A tank that has lost its air charge gives far less.
Do I need a booster pump for a well with a storage tank?
In most cases, yes. Penn State Extension says a booster typically follows the storage tank unless the system can gravity feed the house. Gravity feed needs the tank well uphill, since each foot of height makes only about 0.433 psi. Penn State notes these tanks usually sit at about the same height as the house.
Will a booster pump fix low water pressure from my well?
It can when a slow well is the reason the pressure drops. A tank and booster let the well catch up while the house draws from storage. When the well keeps up, low pressure usually traces to the pressure switch, the pressure tank or the well pump. We test the system and explain the scope before work begins.
How much does booster pump repair or a new booster pump cost?
It depends on the system, and you get a quote before work begins. The pump size and its controls move the price. So do the pressure tank, the run to the house and how easy the site is to reach. Call or text (928) 961-6641 to get started.
More From Jacob's Well and Pump Services

Work That Pairs With Booster Pumps

Rebuilt steel water storage tank set back on its stand with new plumbing

Storage Tanks

We install and repair water storage tanks for homes, ranches and stock water. That covers the tank, its stand and plumbing, the float controls and the booster pump.

Learn More
Bladder pressure tank plumbed to a tank tee with pressure gauge, pressure switch and pump control box

Pressure Tanks

We replace waterlogged and failed well pressure tanks, pressure switches, gauges and tank tees. The precharge gets set to your switch so the pump runs long enough on each cycle.

Learn More
Pickup and a reel of black HDPE pipe on a gravel ranch road, with new water line laid along the shoulder

Livestock Water

We put in and service livestock water systems for ranches, from the stock well to the trough. That covers the pump and its power, storage tanks, float valves and pipeline runs.

Learn More
Why Choose Jacob's Well and Pump Services

Built for Wells in Gila County and the Country Around It

The electrical side gets tested first

Pressure switch, control box, wiring and motor readings come before a pump is pulled. A bad switch is a much smaller repair than a pump.

Our own pump hoist rig and fishing tools

The rig pulls and sets pumps and pipe on shallow wells and deep ones. The fishing tools bring up pumps, pipe and rod that have broken off down the hole.

House, ranch, solar and windmill wells

One company handles the house pump, the stock well, the storage tank, the solar setup and the windmill. The whole water system gets looked at together.

Based in Globe, working about 75 miles out

We cover Gila County and the country around it, on ranch roads as well as in town. A home or a herd with no water moves to the front of the schedule.

Google Reviews

Rated 5.0 on Google by Well Owners Around Globe

Real reviews from real well and pump jobs, 13 reviews on Google.

Read All Reviews

My well is more than 20 years old and began needing repairs. Upon calling Jacob's Well and Pump Service, I was pleased with their quick response and concern to restore my water supply. Prior to the repairs, the scope of work was explained to me, the repairs were made, and the crew always worked in a professional and timely manner. I definitely recommend Jacob's Well and Pump Service.

Dixie Mundy3 years ago · Google review

Great people, very knowledgeable and respectful. Have the equipment to get the job done.

Terri Andress2 years ago · Google review

Jacob's does quality work at a fair price, and always gives the effort required to get the job done right and as quickly as possible. I have worked with them on a number of jobs and they work Iike they are trying to give a good first impression on every project.

Guides and Resources

Booster Pumps Guides

Get a Quote

Get In Touch With Jacob's Well and Pump Services

Tell us what the well is doing and we pick it up from there. Call or text (928) 961-6641, or fill in the form below and we will call you.

  • (928) 961-6641
  • Globe, AZ · serving Globe, Miami, Payson, Tonto Basin, San Carlos, Kearny, Mammoth and about 75 miles around Globe
  • Well pumps, pressure tanks, storage tanks, solar well pumps, windmills and well cleaning

Get a Quote

Tell us what your well is doing. We will call or text you back.

Call (928) 961-6641